Cabac Wall Plug 6G x 25 Red PKT/100 WP25R

The CABAC range of plastic wall plugs are used to anchor screws when fastening to solid wall materials such as masonry. Our wall plugs feature inner laps that close tightly around the screw and ensure it remains centred on a straight path. Outer laps engage with the drilled hole to prevent the plug from spinning as the screw is inserted.

These wall plugs are made from a durable plastic material that maintains its strength over time, even when exposed to chemically destructive agents like oils or acids.

Product Specifications

• Drill Size: 6mm (No. 10)
• Screw Size: 8-9
• Length: 25mm

Note: Wall plugs must firmly grip the sides of a drilled hole and the screw in order to be effective. It is therefore very important to ensure that the drill, screw and plug are suitably matched. In soft masonry such as lightweight concrete you should select a drill 1mm smaller than the size listed above.

Not the size you need? We have a wall plug size guide available, see Additional Information to view the CABAC catalogue or product datasheet.

Installation Tips

Our wall plugs are designed with a tapered cone-shaped tip that makes them easy to insert into a pre-drilled hole. The hole should be deep enough that the flat outer end of the plug sits just behind the wall surface. This can be achieved by placing another plug behind the first and hammering until the first plug has been fully driven home.

Note: These plastic wall plugs are intended for use in solid wall and are not suitable for placement in plaster or joints.